5
REFLECTXION
Switching on the fixture - Fig. 9
Press the switch. The fixture starts resetting the effects. At the same time, the following information scrolls on the display:
Model Firmware xxx (Fixture ID) System errors
REFLECTXION Version X.X.X Dmx Address xxx E: .........................
Date - Hour W: .........................
On conclusion of resetting in case of absence of the dmx signal, Pan and Tilt move to the “Home” position (Pan 128 bit - Tilt 128 bit). The control
panel (Fig. 8) has a display and buttons for the complete programming and management of the fixture menu. The display can be in one of two
conditions: rest status and setting status. When it is in the rest status, the display shows the fixture’s DMX address.
During menu setting status, after a wait time (about 30 seconds) without any key having been pressed, the display automatically returns to rest status.
It should be noted than when this condition occurs, any possible value that has been modified but not yet confirmed with the
F
key will be cancelled.
Dmx Address
Warning Message
Fixture ID
9
Connecting to the control signal line (DMX) - Fig. 8
Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic impedance, 22-24 AWG, low capacity. Do not use
microphone cable or other cable with characteristics differing from those specified. The end connections must be made using XLR type 5-pin male/female
connectors. A terminating plug must be inserted into the last fixture with a resistance of 120Ohm (minimum 1/4 W) between terminals 2 and 3.
IMPORTANT: The wires must not make contact with each other or with the metal casing of the connectors. The casing itself must be connected to the
shield braid and to pin 1 of the connectors.
Connecting to the mains supply - Fig. 7
Connecting fixture to fixture - Fig. 7a
Mains
SIGNAL
SCREEN
DMX 512
5 PIN
1
2
3
4
5
SIGNAL
7
In/Out True1
Max 15 fixtures
Max 1600 VA
Mains
7a
8
Continue
➔
3.3 Connecting the control signal line: DMX / Art-Net
3.4 Switching on the fixture and basic SetUp
Summary of Contents for CA3000
Page 11: ...11 REFLECTXION ...
