SCENIUS UNICO
– User Menu
10
BOARD DIAGNOSTIC
It lets you view the percent errors for each electronic board installed in the projector
0: PT-3f (Pan / Tilt board)
1: 8-Ch (8-channel board)
2: 8-Ch (8-channel board)
3: 8-Ch (8-channel board)
4: 8-Ch (8-channel board)
DMX MONITOR
It lets you view the level of projector DMX channels in bit (Val) and in percent.
FANS MONITOR
It lets you view the speed of each fan installed in the projector:
Lamp (lamp cooling fan)
Pwr.Sup (PSU cooling fan)
Ball.IN (Ballast cooling fan, air-flow IN)
Ball.OUT (Ballast cooling fan, air-flow OUT)
Effect.IN (Effects cooling fan, air-flow IN)
Effect.OUT (Effects cooling fan, air-flow OUT)
Blades (blades cooling fan)
SENSOR STATUS
It lets you check the correct operations of each "sensor” installed in the projector, each channel is associated with one of
the following three parameters:
n.a.= sensor not available
ON= sensor working
OFF= sensor defective
ROT GOBO INDEXING
It lets you check whether the rotating gobo wheel 1 gobo indexing procedure should be run, if indexed, "Indexing Active"
appears on the display, otherwise "Indexing required!” appears
If necessary, indexing should be activated from the Advanced menu.
NETWORK PARAMS
Lets you view the projector "Network" parameters meaning:
IP address: Internet Protocol address (two projectors must not have the same IP address)
IP mask: 255.0.0.0
Mac address:
Media Access Control; the projector’s Ethernet Address.
