4
PRELIMINARY
1. SAFETY INFORMATION
SAFETY INFORMATION
STORMY C71090
STORMY CC C71091
• Installation
Make sure all parts for fixing the projector are in a good state of repair. Make sure the point of anchorage is
stable before positioning the projector. The safety chain must be properly hooked onto the fitting and secu
-
red to the framework, so that, if the primary support system fails, the fitting falls as little as possible. If the
safety chain gets used, it needs to be replaced with a genuine spare.
• Minimum distance of illuminated objects
The projector needs to be positioned so that the objects hit by the beam of light are at least 0.2 metres (8”)
from the lens of the projector.
• Minimum distance from flammable materials
The projector must be positioned so that any flammable materials are at least 0.20 metres (8") from every
point on the surface of the fitting.
• Maximum ambient temperature
Do not use the projector if ambient temperature (t
a
) exceeds 40°C.
• IP20 protection rating
The protection rating of the fitting is IP20. The meaning of the protection rating is:
• Protection against electrical shock
Connection must be made to a power supply system fitted with efficient earthing (Class I appliance accor
-
ding to standard EN 60598-1). It is, moreover, recommended to protect the supply lines of the projectors
from indirect contact and/or shorting to earth by using appropriately sized residual current devices.
• Connection to the power mains
A qualified electrician must perform connection to the power mains. Check that the mains frequency and
voltage correspond to the frequency and voltage for which the projector was designed and indicated on the
electrical data label. This label also gives the input power. Refer to the latter to evaluate the maximum num
-
ber of devices to be connected to the mains to avoid overloads.
The user must determine, in consultation with the supply authority, that the equipment is connected only to
a supply with a maximum permissible system impedence Zmax, at the interface point of the user's supply,
equal or lower to 0.23 Ω.
• External surface temperature
The maximum temperature that can be reached on the external surface of the fitting, in a thermally steady
state, is 100°C (212°F).
• Maintenance
Before starting any maintenance work or cleaning the projector, cut off power from the supply mains. After
switching off, do not remove any parts of the fitting for at least 10 minutes. The lenses must be mounted
and, if visibly damaged, they have to be replaced with genuine spares.
• Photobiological Safety
CAUTION. Do not look directly at the light source.
Do not look at the light beam with optical devices or any other tool that could cause light convergence.
•
This product is intended for the following areas of application: studios, stages, theaters, exhibitions, trade
fairs, events, theme parks, entertainment venues, architectural lighting and similar.
• Not suitable for household illumination.
• Not for residential use.
• Disposing
This product is supplied in compliance with European Directive 2012/19/EU - Waste Electrical and Electro
-
nic Equipment (WEEE). To preserve the environment please dispose/recycle this product at the end of its
life according to the local regulation.
The products to which this manual refers comply with the following European Directives:
• 2006/95/EC - Safety of electrical equipment supplied at low voltage (LVD)
• 2004/108/EC - Electromagnetic Compatibility (EMC)
• 2011/65/EU - Restriction of the use of certain hazardous substances (RoHS)
t
a
< 40 °C
t
c
≤ 100 °C
IP 2 0
Not protected against dripping water, rain, splashes or jets of water.
Protected against penetration by solid bodies of over 12mm (0.47”) in diameter.
Risk Group 1
According to EN 62471
!
