4
Installation Instructions
This product is made with the safest materials conforming to the United States NSF
and according to the relevant CE directives. Proper installation must conform to all
local codes and with US Fuel GAS Code, ANSI Z223.1-1988 or its latest edition.
Within Europe, appliances should be in installed in accordance with BS 6173:1982
code of practice for installation of gas catering appliances, taking into account Gas
Safety Regulations 1984 as amended by the Gas Safety (Installation and Use)
(Amendment) Regulations 1990, 1996 and Health and Safety at Work Act 1974.
Installation of this equipment must be performed by a registered gas-safe gas fitter.
The appliance must be isolated from the gas supply piping system by closing its
individual manual shutoff valve during any pressure testing of the gas supply piping
system at test pressures equal to or less than
½
psi (3.5 kPa). In Europe a gas
soundness test must be carried out.
Unpacking
•
Un-crate the unit with extreme care, do not use a hammer or heavy tools to
un-crate the unit, always use outward prying.
•
Make sure the unit is in the upright position before starting to un-crate.
•
Before fixing the appliance in place, remove all protective plastic
coating from the unit.
•
Oven is on 4”(100mm) wheel castors and can be rolled out easily to the
designated installation area.
•
Unit must be rolled around by hand. Do not use a lift jack.
Clearance and Positioning
•
Do not install propane (LPG) appliances below ground level.
•
This appliance requires a 6”(150mm) clearance from combustible and non-
combustible materials.
•
A clear space of at least 6”(150mm)should be left at the rear and sides of the
appliance.
•
There must be a minimum clearance of 32” in the US and (750mm in Europe)
between top of the appliance and any overhanging shelf. Shelves must be of a
non-combustible material.
•
It is recommended that the appliance is not installed in draughty locations or
near doors.
•
If the appliance is positioned on a combustible floor, sheet metal (preferably
stainless steel) equal to the base area of the appliance must be secured to the
floor prior to fixing the appliance in place.
•
Ensure that the appliance is level.
