Clavia DMI
Service manual Nord Electro rev. 1.2
Page 9
Opening the synth
WARNING
: Take necessary precautions against ESD before opening the synth.
Electro 73
Loosen the screws as shown in
the figure
(2 7x40018).
The two screws on the sides
work as hinges. Lift in the front to
open the top.
Electro 61
Opens similar to the Electro 73
(2 6x40018)
Rack version:
Unscrew the 4 panel screws
(40018)
Gently slide the top
forward and lift it of.
Picture shows Nord Electro 73
Removing the Power Supply Unit
Loosen the five screws
(40262)
holding the PSU to the chassis. Loosen the two screws
(40013)
on the back panel next to the AC socket. Finally remove the 10 pole ribbon cable
(NE 61/73 - 22390 NERack - 22430)
and lift out the PSU.
Removing the Main Board
Loosen the four screws
(40262)
holding the main board to the chassis. Loosen the nuts
and remove the washers around the ¼” jacks on the back panel. Also loosen the four
screws
(40010)
holding the MIDI jacks to the chassis. Remove the 26 pole ribbon cable
(22410)
to the panel board, the 10 pole ribbon cable
(22390)
to the PSU and the two
ribbon cables to the keyboard
(P1-22420, P2-22290).
You can now lift out the main board.
Removing the Panel Board
Pull off all knobs on the front panel (not the buttons). Remove the ribbon cable
(22410)
from the panel board. Loosen the last two screws
(40038)
holding the top to the chassis.
Loosen the nine screws
(40262)
holding the panel board to the upper lid.
You can now lift out the panel board.
Summary of Contents for Nord Electro 2
Page 1: ...SERVICE MANUAL...
