TK3715_IM
17.10.18
35
Use
NOTE:
Always use fresh water.
1.
Place the appliance on a flat surface.
2. Use the handle and remove the lid by pulling it upwards.
3.
WARNING
: Risk of burns!
The tea strainer is hot after previous use! Use oven
mitts or let it cool.
Remove the tea strainer.
4. Fill in the water (max. 1.0 litre). You can read the level at
the MIN and MAX mark of the glass jug.
5. Insert the tea strainer and lightly press it. Pay attention
to the recess and to the proper seat of the sealing ring.
6.
Measure your tea and fill it in the tea strainer.
NOTE:
For some teas with large herbal leaves (e. g. pepper-
mint) we recommend shredding or crushing them so
that it can develop its aroma better.
7. Put the lid back on.
8.
Place the appliance flush on the base.
9. Only connect the appliance to a properly installed safety
socket.
10. Turn the appliance on by using the On / Off switch. The
control lamp next to the switch lights up.
Pausing / Terminating Operation
When the brewing process is complete, the appliance will
stop for approx. 60 seconds. The appliance will then start
with a gush brewing process of approx. 20 seconds. This
allows the tea to develop its aromas better. Brew the tea at
your discretion. Also note the brewing time on the packag-
ing. Switch off the appliance with the On / Off switch after the
gush brewing. The control lamp next to the switch goes off.
CAUTION:
• Do not remove the appliance from the base without
shutting it off first The appliance is switched on as long
as the indicator lamp is illuminated.
• Always shut off the appliance before removing it from
the base! Also ensure that it is turned off when you set
it back onto the base!
WARNING
: Risk of burns!
When pouring the water out, keep the lid closed.
• Remove the mains plug from the socket.
Mains Cable Take-Up Appliance
The mains cable can be wound up on the base.
Cleaning
WARNING
:
• Always turn the appliance off before cleaning it and remove the
mains plug. Wait until the appliance has cooled down.
• Never immerse the appliance or the base into water or other
liquids. Otherwise this might result in an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents
Lid, Tea Strainer, Seal Ring
1. Clean these parts in a rinsing bath.
2. Dry the parts with a cloth.
3. Replace the sealing ring. The opening of the sealing ring
must be under the opening of the tea strainer.
Glass Jug
1. Use a sponge and some detergent to clean the glass
jug.
2. Rinse with clean water.
Housing, Base
Clean the housing and base with a cloth that is slightly moist
and not soaking wet.
