33
MS3654_Instruction Manual_new
01.07.16
• Fill your latte macchiato glass with the warm milk and milk
foam. Then add the espresso. We recommend a proportion
of 2/3 milk and 1/3 frothed milk and 1 cup of espresso.
Caffè Latte
• Use the stirrer to foam (8) the milk and prepare a small
quantity of hot milk as described in the Chapter "Instructions
for Operation".
• Cover a double espresso in a large cup of hot milk with a
little froth.
Cold drinks:
Cappuccino Freddo
• Use the stirrer to foam (8) the milk for a cappuccino freddo
and prepare cold frothed milk as described in "Instructions
for Operation".
•
Fill your cappuccino cup first with espresso and then add
milk foam and cold milk. We recommend a proportion of
1/3 espresso, 1/3 milk froth and 1/3 milk.
Cleaning
WARNING:
• Unplug the power plug before cleaning (6).
•
Never immerse the motor/heating unit (4) into water. It could result
in an electric shock or fire.
CAUTION:
• Do not immerse the appliance in water: the electronic
components can be damaged.
• Do not use a wire brush or any abrasive items.
• Do not clean in the dishwasher.
Motor/heating unit (4)
•
To clean the outside of the motor/heating unit (4), use only
a damp dishcloth with a little dishwasher detergent.
Stirrer (8 or 9) and foam tank (2)
• The stirrer (8 or 9) and the foam tank (2) can be cleaned
in soapy water.
• Let the components dry well before reassembly.
Troubleshooting
Problem
Cause
Solution
The appliance
does not turn
on or stops
operating.
Appliance without
power supply.
- Check the out-
let with another
appliance.
- Insert mains
plug (6).
- Check the
house fuse.
The foam con-
tainer (2) was not
set properly on
the motor/heating
unit (4).
Set the foam tank
(2) correctly on
the motor/heating
unit (4) so that the
safety switch is
depressed.
Problem
Cause
Solution
The device is too
hot. Overheating
protection is
activated.
Allow the appli-
ance to cool.
Appliance
defective.
Contact our
service center or
a specialist.
The milk foams a
little or not at all.
The milk is too
hot.
Use milk at
refrigerator
temperature.
The stirrer for
making foam (8)
was not used.
Insert the stirrer
for creating foam
(8) and prepare
the milk again.
The load capacity
is exceeded.
Fill the tank up to
the MIN level.
Milk escaping
from the lid.
The load capacity
is too large.
Reduce the load
capacity.
The LEDs flash
when apparatus is
switched on.
The device was
turned on without
a properly insert-
ed foam tank (2).
Insert the foam
tank (2) on the
motor/heating unit
(4) and turn on
the unit again.
Summary of Contents for MS 3654
Page 55: ...55 MS3654_Instruction Manual_new 01 07 16 ...
Page 56: ......
Page 57: ......
Page 58: ...MS 3654 Stand 07 2016 ...
