Clatronic HTD 3055 PROFI, Instruction Manual

Page: 32 / 60

32
Commissioning
• Unwind the mains cable completely.
• Attach a nozzle if necessary.
• You can dry single hair locks by concentrating the flow
of hot air with the hairdressing nozzle.
• The diffuser is the ideal solution to dry curly hair without
losing volume.
• In order to replace the attachment, first remove the old at -
tachment by pulling it off and then pushing on the new one
until it clicks into place.
Electrical Connection
• Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the appliance to a properly installed earthed
socket.
Use
Setting the Temperature Level (right switch):
Position • : cold air
Position •• : medium temperature for gentle drying and
shaping
Position ••• : high temperature for rapid drying
Setting the desired blower strength (left switch):
Position 0 : cold air
Position : gentle stream of air
Position : strong stream of air
Button : With this switch it is possible to interrupt
the heating process so that the air can be
mixed according to individual requirements.
Hold the button down in this position ac -
cording to the desired interval length. When
the button is released it returned automati -
cally to the initial position.
Switch-off
After use, slide the switch to position “ 0 ” and disconnect from
the mains.
Storage
• Leave the device to cool before putting it away! To do so,
place the appliance onto one side of the housing or hang it
up by the suspension eye.
• Fold the handle up to save space and keep the appliance
in the see-through bag.
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time
this may result in the cable breaking.
• Check the mains cable regularly for damage.
Maintenance and care
WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additives.
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer
regularly in order to avoid excessive temperatures as a result of
heat accumulation.
• Remove any dirt that is present.
• If necessary, a fine brush can be used.
• Twist off the grille in an anticlockwise direction, remove the
air inlet filter and clean it under running water.
• Please allow the filter to try before reinserting it.
• Turn the grille tight in a clockwise direction.