Clatronic DR 2765, Instruction Manual

Page: 36 / 57

Caution! Before unscrewing the lock (3) proceed as follows:
• Remove the power plug from the socket.
• Release the pressure by using the steam switch.
• Slightly loosen the lock (3). Wait for a few seconds before removing the lock
completely.
Overview of the Controls
1. Housing 9. Round brush
2. Connection nozzle 10. Curved nozzle
3. Safety lock 11. Jet nozzle
4. Steam switch 12. Hose
5. Handle 13. Brush for fabrics
6. Connection cable 14. Window wiper
7. Funnel 15. Cloth
8. Measuring beaker
Initial Operation
Filling up the Heating Boiler before Use!
Before the tank lock is opened the power plug must be removed from the
socket. Please make sure the device is depressurized by pressing the steam
switch.
Caution! Danger of Injury!
Please open the safety lock (3) only when no more steam comes out of the
nozzle. Pour out any residual water in the boiler. Fill water from a measuring bea-
ker (8) through the funnel (7) into the boiler. Re-fasten the safety lock (3).
Attachment of the Individual Accessories
Round brush, curved nozzle
The round brush and the curved nozzle can be attached to the jet nozzle at the
hexagonal joint.
Jet Nozzle, Hose, Brush for Fabrics and Cloth
1. Push the attachment on to the device as far as it will go. The mark on the nozz-
le and the yellow mark on the device must be aligned with one another.
2. Turn in the direction of the arrow (clockwise) until the mark on the attachment is
aligned with the line on the device. The attachment remains blocked in this posi-
tion.
• The jet nozzle can be used on the hose or directly on the device.
• The hose (12) has to be attached to the connecting nozzle (2). Then the jet
nozzle (11) and the fabric brush (13) can be attached to the end of the hose.
36
GB
5....-05-DR 2765 23.10.2002 8:48 Uhr Seite 36