First Use of the Machine
Numbering of the Controls
1. Steam regulator
6. Spray button
with self-clean function
7. Steam-jet button
2. Filler aperture of the water tank
8. Control lamps
3. Temperature control
9. Contact plate
4. Water tank
10. 3-position function switch
5. Base
•
Clean the ironing base with a slightly damp cloth.
•
Fill the water tank through the filler aperture (2) with pure water (up to degree of
hardness 2). If the tap water is harder please use distilled water. Use the filling
vessel.
Using the Machine
NOTE: Only clothes should to be ironed with this machine.
Ironing without steam (steam regulator turned to position "0")
1. Place the iron on its stand
2. Sort out the garments according to their ironing temperatures. Start with the
lower temperatures. It is set with the thermostat (3):
Synthetics, silk
(low temperature)
Wool (medium
temperature)
Cotton, linen
(high temperature)
3. Insert the plug into a correctly installed safety power socket, 230 V, 50 Hz.
4. The control lamps light up. As soon as the blue control lamp goes off the opera-
ting temperature has been reached (approximately 3 minutes). Now you can
start ironing.
5. Always pull the plug out of the socket after using the iron.
Steam Ironing
For this a high temperature is needed (cotton, linen). The quantity of steam can be
regulated using the steam quantity regulator (1).
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
Self-Cleaning
1. Half fill the water tank with water.
2. Heat the machine up to its maximum temperature. After the blue control lamp
has gone off, disconnect the machine from the mains.
31
GB
38417-05-DBS 2580 08.09.2004 16:48 Uhr Seite 31
