w w w . c l a s s i c
e x h i b i t s . c o m
Step 1
Page 1 of 3
866.652.2100
© 2014
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX - Workstation Assembly
DOOR
Laminated Infill
D (w/ Door Stopper)
Knobs face INSIDE
of workstation
Knobs face INSIDE
of workstation
Black
Knob
Turn Knob Clockwise
to Tighten Lock
A (left)
B (right)
C
F
Knobs face FORWARD
Knobs face INSIDE
of workstation
Pins are
located on INSIDE
FRONT vertical
of Leg
Assemblies
Align with bottom of leg assemblies [A and B].
Part Number
A
B
C
D
F
Steps:
1) Connect lower horizontal extrusion [C] between bottom of leg assemblies [A and B] as shown.
2) Connect upper horizontal extrusion [F] between top of leg assemblies [A and B] as shown.
3) Insert Laminated infill into grooves of leg assemblies [A and B].
4) Attach extrusion door between leg assemblies [A and B] and atop laminated infill.
5) Attach upper horizontal extrusion w/ door stopper [D] between leg assemblies [A and B],
and set flush with top of legs [A and B].
Description
Left Leg Assembly
Right Leg Assembly
Horizontal Extrusion
Horiontal Extrusion w/ Door Stopper
Horizontal Extrusion
NOTE: Make sure the lock is flush with
extrusion before tightening. If lock will
not fully engage, gently rock lock and
extrusion back and forth while turning
knob until lock fully opens.
