Classe Audio CDT-300, Owner'S Manual

Page: 17 / 84

17
ENGLISH
8 AC Mains Power Switch
The main power switch for the CDT-300 is located at the right side of the
rear panel. The transport should be in
standby mode before being switched
off. Switching the unit on puts it in standby mode.
Danger! Potentially dangerous voltages and current capabilities exist
within your DVD transport, even when disconnected from AC
mains. Do not attempt to open any portion of the transport’s
cabinet. There are no user-serviceable parts inside your DVD
transport. All service of this product must be referred to a
qualified authorized Classé dealer or distributor.
9 AC Mains Input
An IEC standard power cord (supplied) is used with the CDT-300. Plug
the cord into the IEC outlet provided, and the other end into a suitable
wall outlet.
The AC inlet assembly includes a built-in fuse for the protection of the
unit in case of major AC mains problems and/or component failure.
If your CDT-300 ever behaves as though it were not connected to the
AC mains (meaning it seems completely dead), remove the AC cord from
the unit and open the fuse holder immediately above the AC cord inlet.
If the fuse is blown, replace it with the spare fuse contained in the fuse
holder. If the spare fuse blows, take the unit to your qualified Classé dealer
immediately.
Caution: There are no user-serviceable parts inside the CDT-300. Do
not attempt to diagnose the problem yourself.