OE 2001
TYPE 1 WALLBOX WIFI REEL FOR ELECTRIC VEHICLE
POWER SUPPLY
INSTALLATION INSTRUCTIONS
The cable winder must be safety secured to the wall or to the ceiling with 2 screws Ø6x40 mm or longer
(FIG.1), verifying beforehand the solidity of the installation surface.
The cable retainer (2) must never be moved towards the plug.
Connection to the power supply must be made by qualified staff in compliance with standards enforced in
the country of use.
Connection to earth is essential.
The product must be fitted in a dry place, at a minimum height of 1.40m from the ground.
The wiring must be permanent, protected by a 16A curved C bipolar magnetothermic and a 30mA type A
differential.
For vehicles with high frequency dispersion such as the Renault Zoe it is necessary to use a special differential
which is immune to that type of disturbance.
The auxiliary relay (FIG.4) (7) can perform different functions depending on the position of the first two dip
switches (8) as shown in table “A”, and can bear a maximum load of 3A - 250V AC.
To access the auxiliary relay (7) open the door (6) by unscrewing the screw (FIG.3).
In case of overheating, detected by the temperature probe, the power supply is gradually reduced to
decrease the internal heat dissipation; as the temperature goes down, its nominal value is slowly restored.
This condition is signalled by short flashes of the red power LEDs (11).
To clear the error, press and hold the buttons (9 and 10) (FIG 5) simultaneously for 5 seconds, or turn off the
power and re-power the winder.
INSTRUCTIONS FOR USE
Winding
Pull the cable out to the desired length. Cable locking is inserted every 50 cm. A click is audible.
Performance
Carefully pull out the cable, a click is heard. As soon as the click is no longer audible, the locking is exceeded
and the cable can be rolled up again.
Never release the cable during winding; danger of injury!
Removing the product, in part or in full, is prohibited.