7
English
Instructions for use
Before initial use
• Wash the glass carafe and filter holder before initial use.
• Before using the coffee maker you should run the machine through two to three
filtration cycles at full water capacity, but without coffee grounds. This should also be
done when the coffee maker has not been used for a long time, and after descaling.
• The water level scale on the water reservoir makes it easier for you to fill the reservoir
with the correct amount of water. Make sure not to exceed the maximum water level.
Warning:
Hot steam will come out of the top of the coffee maker during
the brewing process. Do not touch or lift the water reservoir cover whilst brewing is in
progress. Let the coffee maker cool before lifting the water reservoir and filter cover.
Setting the time
1. Plug the mains lead into a wall socket. The display lights up and shows “0:00”.
2. Press [ TIMER ], “CLOCK PROG” and the hour digits will flash.
3. Press or hold in [ + ] or [ − ] to set the hours.
4. Press [ TIMER ] again – the minute digits will flash.
5. Press or hold in [ + ] or [ − ] to set the minutes.
6. Press [ TIMER ] to exit the settings mode.
Information:
If you need to reset the time, hold in [ TIMER ] until “CLOCK PROG”
and the hour digits flash. Set the time according to the instructions above.
Manual brewing
1. Lift the lid (5) and add the desired amount of water and ground coffee. You can either
use the included reusable filter or a disposable size 1×4 paper filter (sold separately).
2. Close the lid.
3. Close the lid on the carafe and place the carafe onto the warming plate. The carafe
must be positioned correctly in order for the drip-stop mechanism on the filter
holder to function correctly.
4. Press [ BREW ] to start brewing. The word “BREW” will show on the display and
the red LED indicator (8) will come on. The coffee maker will emit an audible signal
when it has finished brewing.
5. Wait until all the water has run through the filter before removing the carafe from
the warming plate.
-
The coffee maker automatically enters keep-warm mode once brewing is complete.
It will switch off automatically 40 minutes after it was switched on.
-
Press [ BREW ] to switch the coffee maker off before the 40 minutes has elapsed.
-
Make sure that the coffee maker is switched off after use.
