![Clas Ohlson 36-8321 Original Instructions Manual Download Page 16](http://html1.mh-extra.com/html/clas-ohlson/36-8321/36-8321_original-instructions-manual_2616779016.webp)
16
English
Setting the desired humidity when the
Set
mode is selected
• When the dehumidifier is switched on, the display shows the current humidity in
the room in which the dehumidifier is located.
• If the humidity in the room is e.g. 40 % and the appliance is set to maintain
a humidity level of 60 %, the compressor in the dehumidifier will not operate.
1. Press [ − ] or [ + ] to set the desired humidity. The humidity level can be set in
the range 35–85 % RH in increments of 5 %.
2. When the desired humidity level has been reached the dehumidifier will switch off
automatically.
Timer setting
Setting the stop time
1. Make sure that the dehumidifier is
switched on
.
2. Press the timer button (10).
3. Set the desired stop time by pressing or holding down the [ − ] or [ + ] button.
The time is changed in 30-minute increments up to the 10-hour mark. Thereafter
in increments of 60 minutes. The display shows the set timer time for 5 seconds
before reverting to whatever is was displaying previously.
Setting the start time
1. Make sure that the dehumidifier is
switched off
.
2. Press the timer button (10).
3. Set the desired start time by pressing or holding down the [ − ] or [ + ] button.
The time is changed in 30-minute increments up to the 10-hour mark. Thereafter
in 60-minute increments up to the 24-hour mark. The display shows the set timer
time for 5 seconds before reverting to whatever is was displaying previously.
• The timer button (10) can be pressed at any time to check the settings.
• The timer settings can be changed at any time by pressing the timer button (10)
and then the [ − ] or [ + ] button.
• If the dehumidifier is switched off after the timer settings have been made,
the settings will be deleted.
• If the water tank becomes full (P2 appears on the display) while the dehumidifier is operating
and before the set timer time has been reached, the timer setting will be deleted.
Automatic shut-off
• When the water tank becomes full during use, the dehumidifier compressor shuts
off automatically.
• The fan will continue for a few seconds to dry the inside of the dehumidifier.
• The dehumidifier will beep, the ‘Full’ indicator will flash and ‘P2’ will appear on the display.