Clas Ohlson 31-4985, Manual

Page: 7 / 56

7
E
n
g
li
s
h
Installation
Choosing a location
It is important to choose a suitable location for the hot tub BEFORE filling it with
water. To make assembly and use of the hot tub as unproblematic as possible,
use the following guidelines when choosing a location for the hot tub:
1. Make sure that the ground is firm, flat and level. WARNING: Hot tubs located on
uneven ground can start to leak, deform or collapse, resulting in possible damage
to property or injury to people around the hot tub. Never use sand or other sub-
stances to level the ground underneath the hot tub.
2. Clear the ground of stones, twigs, rubbish and any sharp objects before spreading
out the hot tub. Use a groundsheet if appropriate.
3. Do not choose a location directly under overhead power lines or trees or within
5 metres of a building. Make sure that there are no buried electrical, telephone or
gas lines under the location in which you plan to set up the hot tub. Do not place
the hot tub onto wooden decking tiles, wood or any material treated with an oil-
based solution.
4. Do not locate the hot tub close to balconies or other raised platforms. This will
eliminate the temptation for people to jump into the hot tub from heights, resulting
in possible injury.
5. Choose the location of the hot tub carefully since any lawn or plants lying under-
neath the hot tub will most likely not survive. You should avoid locations with
certain species of weeds that can grow up through the bottom of the hot tub.
6. If possible, the hot tub should be placed in direct sunlight which helps the warming
process substantially.
7. Never drag the hot tub over the ground. Your hot tub is a delicate product which can be
easily damaged if not given the proper care. Be safe and carry it to the chosen location.
Testing the RCD
Always test the hot tub’s RCD before using the hot tub.
1. Connect
the mains lead
to an earthed
wall socket.
2. Press [ RESET ]
and check that
the indicator
lights red.
3. Press [ TEST ]
and check that
the indicator
light turns off.
4. Press [ RESET ]
and check that
the indicator
lights red.
If all steps correspond to the description described above, the hot tub is ready for use,
otherwise consult an electrician.