EN
G
LI
S
H
9
Use
Changing the spindle speed
The spindle speed can be altered by moving the belt between the pulleys. The machine is equipped
with a safety switch which automatically shuts off the machine if the belt cover is opened.
Move the belt like this
1. Open the belt cover by loosening the screws on the right side of the cover.
2. Undo the locking lever (2).
3. Move the belt to the position giving you the desired speed. Use the table on the inside of
the belt cover.
4. The belt is automatically tensioned by a spring but may tensioned a little more by pushing
the motor away from the main body. Lock the locking lever (2). The belt is correctly tensioned
when you can flex it approx. 1 cm.
5. Close the belt cover and screw it down so that the machine can be used.
Spindel Speeds
Belt Position
Rpm
A.
2650
B.
1880
C.
1370
D.
900
E.
580
Table depth stop
The table is fitted with a depth stop (17) which can be adjusted using 2 lock nuts (18).
Chuck
Drills and cylindrical shafted tools up to 13 mm in diameter can
be fastened in the chuck with the chuck key.
Securing the workpiece
The table is slotted so that the drill press vices can be bolted to it.
Adjusting the table
The table can be moved up and down the column when
the locking lever (6) on the back of the table support (4) is
undone.
Adjust the table (14) so that there is enough room between
the drill and the table for the workpiece. The table can also
be moved to the side if you wish to fix a workpiece directly
to the base of the drill (7).
