Clarke Woodworker CDS300, Operating & Maintenance Manual

Page: 9 / 12

For greater accuracy, the mitre gauge is used so that the work may be held at a
required angle and moved across the disc as shown in Figs. 1 and 2.
Use a slight pressure ONLY... let the disc do the work. Pressure should be on the
DOWNWARDS direction of motion of the disc ONLY. i.e. on the left half of the disc
as shown in Figs.1 and 2.
NOTE:
Replacement sanding discs (packets of 5) in three different grit sizes are available
from your Clarke dealer. (See Accessories below).
We STRONGLY recommend that a dust extraction device is used with this machine.
Simply attach a suitable hose from the dust extractor to the outlet, beneath the
table. A vacuum cleaner may be used for this purpose if a purpose built dust
extractor is not available. (Dust extractors are available from your Clarke dealer).
Fig.1
Fig.2
MAINTENANCE
ALWAYS disconnect the machine from the mains supply BEFORE performing any
maintenance operation.
The machine is completely maintenance free, with the exception of ensuring it is
kept clean and free from build up of sawdust at all times. This should be carried
out with an old paintbrush or similar, and a vacuum cleaner.
The panel beneath the table is secured by two screws. Remove these to gain
access to the lower half of the disc.
ACCESSORIES
Sanding Discs, self adhesive (Packets of 5)
1. 60 Grit ................................................... Part No. 6502305
2. 80 Grit ................................................... Part No. 6502310
3. 120 Grit ................................................. Part No. 6502315
9