14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
APPLYING DETERGENTS AND CLEANING AGENTS
To improve the cleaning performance, you can introduce chemical cleaning
agents (detergents) to the water jet using the detergent pickup hose.
1. Remove the detergent tank cap
2. Fill the tank with a suitable CLARKE
detergent and replace the cap.
•
Only use detergents
recommended for use with
pressure washers, such as
CLARKE Traffic Film Remover
which is a powerful low
foaming agent for car
cleaning, patio cleaning etc.,
or CLARKE Wash & Wax, both available from your CLARKE dealer.
3. Hold the rear of the nozzle on the
high pressure lance and slide the
front of the nozzle forwards to low
pressure.
4. Spray the detergent onto the
vehicle, patio etc.
•
Allow the detergent a little time
to work itself into the grime.
5. To rinse, slide the front of the nozzle on the lance back towards the handle
and use the pressure washer as normal.
SHUTTING DOWN
1. After each use, if you have
applied chemicals, slide the front
of the nozzle on the lance back
towards the handle and operate
the pressure washer for a short
time to flush the the hoses.
2. Move the throttle control lever to
the right.
CAUTION: IF YOU GET CLEANING FLUID IN YOUR EYES, RINSE THEM
IMMEDIATELY WITH PLENTY OF FRESH CLEAN WATER. AND SEEK MEDICAL
ADVICE IF REQUIRED.
Summary of Contents for TIGER 3000A
Page 28: ......
