- 18 -
4. SPRAY GUN MAINTENANCE
1.
Immerse only the front end of the gun until solvent just covers the fluid
connection.
2.
Use a bristle brush and solvent to wash off accumulated paint.
3.
Do not submerge the entire spray gun in solvent because:
a.
the lubricant in the gland packings will dissolve and the packings will dry
out.
b.
the lubricant will dissolve causing harder operation and faster wear.
c.
residue from dirty solvent may clog the narrow air passages in the gun.
4.
Wipe down the outside of the gun with solvent dampened rag.
5.
Lubricate gun daily. Use a light machine oil on:
a.
fluid needle packing.
b.
air valve packing.
c.
fan control packing.
d.
trigger pivot point.
Coat the fluid control spring with vaseline.
Caution: Never use lubricants containing silicone as this may cause finish defects.
For a professional looking finish paint must be thinned. If the manufacturers
recommendations on thinning are not available, the following can be used as a
general guide: Water based paints (emulsions) - 10-20% water
Oil based paints (gloss) - up to 10% white spirit thinners
Cellulose paints - up to 50% cellulose thinners
3. HANDLING THE GUN
The first requirement for a good resultant finish is the proper handling of the gun.
The gun should be held perpendicular to the surface being covered and moved
parallel to it. The stroke should be started before the trigger is pulled and the
trigger should be released before the stroke is ended. This gives accurate control
of the gun and material.
The distance between gun and surface should be 6 to 12 inches depending on
material and atomizing pressure. The material deposited should always be even
and wet. Lap each stroke over the preceding stroke to obtain a uniform finish.
NOTE: To reduce overspray and obtain maximum efficiency, always spray with the lowest
possible atomizing air pressure.
- 3 -
Thank you for purchasing this CLARKE SPYDER Oil Free Air Compressor,
which is designed for hobby and DIY use only.
Please read this leaflet thoroughly and carefully follow all instructions. In
doing so you will ensure the safety of yourself and that of others around
you, and you can look forward to the compressor giving you long and
satisfactory service.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof
of purchase. This guarantee is invalid if the product is found to have
been abused or tampered with in any way, or not used for the purpose
for which it was intended.
Faulty goods should be returned to their place of purchase, no product
can be returned without prior permission. This guarantee does not
effect your statutory rights.
CONTENTS
Page
Specifications ............................................................................ 2
Safety Precautions ..................................................................... 4
Electrical Connections .............................................................. 5
Operating Instructions ............................................................... 6
Routine Maintenance ................................................................ 7
Accessories ................................................................................ 9
Troubleshooting ....................................................................... 10
Parts List (Pump) ....................................................................... 12
Parts Diagram (Pump) ............................................................. 13
Parts List (Receiver)
............................................................ 14
Parts Diagram (Receiver) ................................................... 15-16
Paint Spraying Hints - General preparation ......................... 17
Preparing the paint ........................... 17
Handling the gun .............................. 18
Spray gun maintenance .................. 18
Declaration of Conformity ...................................................... 19
