6
PREPARATION FOR USE
NOTE:
All numbered items throughout this manual refer to the parts list item number
on Pages 12 to 15.
1.
Remove the plastic travel plug from the oil filler hole, on the
top of the crank case, and insert the dipstick (see Fig. 6 - p.9).
2.
Check the oil level is at the correct level on the dipstick, as
shown in Fig.1. Where necessary, top up with Clarke SAE40
Compressor Oil (available from your Clarke dealer).
OPERATION
(Ref. Fig. 2)
NOTE:
if you intend using your compressor for spraying, read also the “Helpful
Hints on Spraying” booklet - supplied with the machine.
1.
Check that the mains voltage corresponds with that shown on the data sticker
on the crankcase cover of the machine.
2.
Ensure that the ON/OFF knob is in the ‘OFF’ (0) position, i.e. pushed DOWN,
then plug in and switch on at the mains supply.
3.
To start the compressor pull UP the ON/OFF knob to the ‘ON’ (I) position
- the motor should start immediately.
Fig.1
Fig. 2
Illustration is of
Rebel 30.
Component
layout for the
Rebel 60 is the
same,
although some
components
differ slightly in
appearance
