CLARKE TECHNOLOGY PB-12 Operator's Manual
Page 13
How to Install The Brush Drive Belt
To install the brush drive belt, follow this procedure:
1. Turn the machine so that the left side is up.
2. Put the belt on the pulley.
3. Make sure the spacer is in position between the out-
side frame and the pulley. See figure 21.
4. Install the pulley.
5. Install the bolt that holds the pulley. See figure 22.
6. Install the belt guard with the three holding screws.
7. Turn the machine so that the right side is up.
8. Install the brush with the two screws that hold the
brush.
9. Install the belt on the pulley on the motor.
10. Install the belt, slide the motor toward the back of the
machine. The tension of the belt is corrrect when the
belt is tight but not extended.
11. Tighten the four screws that hold the motor.
12. Close the cover.
WARNING: To prevent electrical shock, always
disconnect the electrical plug from
the electrical outlet before doing any
repair or maintenance to this ma-
chine.
WARNING: Maintenance and repairs must be
done by authorized personnel only.
After each use of the machine, follow this procedure:
1. Flush the solution system with clean water from
the extractor.
2. Disconnect the solution hose and the vacuum hose
from the machine.
3. Drain the solution system. To drain the solution
system, press the pin in the male connector. Apply
pressure to the brush and solution lever.
4. Disconnect the plug from the electrical outlet. For
storage, put the electrical cord around the cord hook
and the top of the handle.
5. Use a stick of wood approximately six inches long
to remove the carpet fibers and objects caught un-
der the brush housing.
6. Wipe the machine with a dry cloth.
7. Check the objects in the vacuum opening. Use a
stick to remove any objects caught under the brush
housing. See figure 23
8. Check for leaks at all connections.
CAUTION: To prevent damage to the spray jet,
do not push a wire or other object
through the opening in the jet.
Figure 21
Figure 22
Figure 23
Summary of Contents for PB-12
Page 16: ...CLARKETECHNOLOGY PB 12 Operator s Manual Page 15 NOTES ...
Page 23: ...NOTES ...
