14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6. Lower the cover and slide it
forward to close.
7. Pull off the torch shroud with a
twisting movement, then unscrew
the contact tip.
8. Connect the welder to the power
supply and switch ON.
9. Set the ‘WIRE FEED’ rotary control
on the front panel to position 7 or
8 and squeeze the trigger on the
torch body.
• The wire will feed through the
hose until it appears at the
torch tip.
• Ensuring the hose is free from
kinks during this process will
assist the wire in its passage
through the hose liner.
10. Release the trigger and switch off the welder and disconnect the machine
from the mains supply.
11. Refit the contact tip (0.9 mm is supplied fitted) to suit your wire. then
replace the shroud.
12. Trim the welding wire so that it protrudes no more than 5 mm from the end
of the contact tip.
Summary of Contents for MIG102NG
Page 24: ......
