Clarke MIG 100E, Operating & Maintenance Manual

Page: 15 / 35

UNPACKING & PARTS IDENTIFICATION
Unpack and lay out the components, checking against the following list. Any
damage or deficiency should be reported to your CLARKE dealer immediately.
Most of the components are stored within the side compartment. To open the
compartment, slide the side cover upwards.
15
MIG150TE
1. Welder complete with Torch and Hose,
Earth Cable with Clamp and Power cable.
2. 1 plastic foot
3. 2xWheels w/Axle + 2 Locking washers.
4. 1xHandle Extension w/screw
5. 1xHandle
6. 1x2-Piece Welding Mask
7. 1xWelding Mask handle, complete
with plastic nut and 2xplastic screws.
8. 1xPackage containing 1x Clear Glass
and 1x Dark Glass Lens
9. 1xMini Wire Spool, (fitted to the Spool
Holder)
10. 1xDisposable Gas Cylinder CO
2 .
11. 1xGas Regulator
12. 1xLarge Worm Drive Fastening Band
13. 1xLarge Gas Bottle Adapter
13. 1xbag containing
a. 1x0.8mm welding tip
b. 1x1.0mm welding tip
NOTE: A 0.6mm tip is fitted to the torch
PRO MIG-90 & MIG100E
1. Welder complete with Torch and Hose,
Earth Cable with Clamp and Power
cable.
2. 1xHandle
3. 1x2-Piece Welding Mask
4. 1xWelding Mask handle, complete
with plastic nut and 2xplastic screws.
5. 1xPackage containing 1x Clear Glass
and 1x Dark Glass Lens
6. 1xMini Wire Spool, fitted to the
Spool Holder
7. 1xDisposable Gas Cylinder CO
2
8. 1xGas Regulator
9. 1xLarge Worm Drive Fastening Band
10. 2 alternative welding tips (1only with
PRO-90)
11. 1xLarge Gas Bottle Adapter (NOT PRO-
90)
NOTE: A 0.6mm tip is fitted to the torch
MIG PRO-90 is of similar layout