MAINTENANCE
For maximum performance, it is essential that the Drill Press is properly maintained. Always
inspect the machine for damage, and security of components before use. Any damage
should be repaired, and faults rectified.
If the mains lead is worn, cut or damaged in any way, it should be replaced immediately.
Please refer to the trouble shooting chart on page 16. If you are unable to rectify any faults,
please contact your local dealer or Clarke International Service Division on 020 8556 4443 for
assistance.
Monthly
(When in constant use)
1.
Check tightness of mounting bolts, and head and column securing set screws.
2.
Check belt for wear and replace if frayed or damaged in any way.
3.
Blow out any dust that may have accumulated in the motor fan.
4.
Apply a thin coat of wax paste or light oil to the table and column for lubrication and
to help prevent corrosion.
Lubrication
All bearings are packed with grease at the factory and require no further lubrication.
After use
Remove all swarf from the machine and thoroughly clean all surfaces.
Components should be dry, with machined surfaces lightly oiled.
Always remove drill bits, and store in a safe place.
14
Summary of Contents for METALWORKER CDP201B
Page 1: ...0307 SERIAL No ...
Page 18: ...HEAD ASSEMBLY 18 ...
