8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
JUMP STARTING
NOTE:
This device will not jumpstart a vehicle if the battery is very low or
completely flat.
CONNECTING THE SMART CABLE TO THE POWER PACK
1. When jumpstarting, a minimum of
3 of the power indicator lights
located on top of the device must
be lit. Recharge the device if
required.
2. Lift the rubber plug and insert the
EC5 connector of the smart lead
into the power pack.
• The red & green LEDs on the
smart lead flash alternatively.
CONNECT THE JUMP START LEADS TO THE BATTERY
1. Connect the red clamp to the unearthed battery terminal first, (this is
usually the positive (+ve) terminal and coloured RED).
2. Connect the black clamp to the earthed battery terminal, (this is usually
the negative (-ve) terminal and coloured BLACK)
3. Once you have connected the leads you have 30 seconds to try and start
the vehicle, otherwise you will need to remove the leads and reattach
them.
WARNING: SOME VEHICLE ELECTRONIC EQUIPMENT MAY BE DAMAGED
BY JUMP STARTING. ALWAYS CHECK WITH THE VEHICLE HANDBOOK
WARNING: DO NOT USE ON DIESEL ENGINES.
Summary of Contents for JSM200
Page 11: ......
