ASSEMBLY AND PREPARATION FOR USE.
A. High Pressure Hose
Remove the plastic travel cap from the threaded high pressure outlet,
and screw on the high pressure hose firmly.
The outlet on the Jetstar 1550 and 1600 models is at the front of the unit - opposite
end to power cable inlet, on the Jet 3000 model, it is mounted on the front -
handle end.
B. Lance
At the opposite end to the nozzle is a a spigot with two integral lugs, and
a rubber O-ring. Ensure the O-ring is in place and in good condition.
Insert the spigot end of the lance into the trigger/handle assembly. Push
home firmly and twist to lock it in position. Twist anticlockwise looking down
from the handle end. DO NOT attempt to disassemble the lance.
NOTE: When new, the lance may be a tight fit and a little lubrication, with
vaseline or similar, will assist when joining the parts together.
C. Water Supply Hose
Remove the temporary travel cap from the threaded inlet connection
and ensure that the sealing ring is in place.
The water inlet on the Jetstar 1550 and 1600 models is on the left front of the
unit, on the Jet 3000 model it is mounted on the bottom left - handle end.
Attach a suitable hose to the inlet hose connector, and secure with a
worm drive clip, (hose and worm drive clip are not supplied).
NOTE:
1. Use a good quality hose of at least 1/2" (13 mm) diameter.
2.
Check to ensure that the filter is correctly located inside the inlet connection.
Screw on the inlet connector, with hose attached, to the water inlet. This
connection must be tight to avoid leaks.
Secure the other end of the hose to your tap using a suitable tap adaptor
(not supplied) CLEAN, cold or hot water (up to 50°C) can be used.
NOTE:
1. In some areas, it may be necessary to ensure that you comply with
local bylaws concerning the use of water from the mains supply, and
the disposal of possibly contaminated water.
2. Hose, worm drive clips and other accessories are readily available
from all good DIY, Hardware and Garden Supplies Stores.
6
PARTS LISTS & DIAGRAMS
J
etstar 1550
Jetstar1600
No.
Description
Part No.
Part No.
1
High Press. Hose c/wHandle Assy
FP60600107.88
FP60600107.88
2
Lance Assembly
FP60710100
FP60710000
3
Detergent Lance c/w plastic tube
FP60603800
FP60603800
4
Detergent Bottle
FP15603400
FP15603400
-
Detergent Bottle Cap
FP15603401
FP15603401
5
LP Water Inlet Adapter c/w O-Ring
and Rubber Washer
FP18106400
FP18106400
-
Hex. Wrench (for turning motor)
FP15607000
FP15607000
-
Water Inlet Filter
FP52066500
FP52066500
J
etstar 1550 & Jetstar1600
11
