ELECTRICAL CONNECTIONS
WARNING: THIS MACHINE MUST BE EARTHED.
This product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug, for
connection to a standard, domestic electrical supply.
Should the plug need changing at any time, ensure that a plug of identical
specification is used. IMPORTANT: The wires in the mains lead should be wired up
in accordance with the following colour code:
Green & Yellow ............................. Earth
Blue ................................................ Neutral
Brown ............................................. Live
As the colours of the wires in the mains lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
•
Connect GREEN & YELLOW coloured cord to plug terminal marked with a
l
etter “E” or Earth symbol “ ”.
•
Connect BROWN coloured cord to plug terminal marked letter “L”
•
Connect BLUE coloured cord to plug terminal marked letter “N”
We recommend that this machine is connected to the mains supply through a
Residual Current Device (RCD).
FUSE RATING
The fuse in the plug for this appliance must be ASTA approved to BS1362. AND
rated at
13 amps
IMPORTANT:
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e.
non-rewirable) :
1.
The plug must be thrown away if it is cut from the electric cable. There is a
danger of electric shock if it is subsequently inserted into a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4.
Replacement fuse covers can be obtained from your local dealer or most
electrical stockists.
EXTENSION CABLES
If an extension cable is used, always ensure it is fully unwound. When used
outdoors, ensure the extension cable is specifically designed for outdoor use.
The maximum extension length is 25 metres. Ensure that the wire sizes in the cable
is at least 0.75mm
2
in cross section. As a general rule, the extension cable must be
thicker than the cable supplied with the washer.
IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
Do not attempt any electrical repairs yourself.
5
Part Nos. for Jet 3000 are the same as those for Jetstar 1600, except for item 5,
which has 3 components shown below, the Hex wrench, plus additional
components:
5A
LP Water Inlet Adapter Ring
FP52037300
5B
LP Water Inlet Adapter Gasket
FP52037400
5C
LP Water Inlet Adapter Hose Holder
FP52037500
-
Hex. Wrench (for turning motor)
FP15609900
6
Wheel
FP17807000
7
Axle
FP52436400
8
Axle Clamps
FP50
148700
No. Description
Part No.
Jet 3000
12
