8
Bucket
containing
antifreeze
On top of the foam attachment is a yellow knob with a serrated edge, which can
be turned clockwise or anticlockwise to adjust the amount of detergent allowed
into the water jet. Turn the knob clockwise to reduce the amount and anticlockwise
to increase.
To rinse and clean, set the trigger safety latch, and remove the foam attachment
as follows:
Pull DOWN on the locking latch, in the
direction of the arrow, as shown in the
diagram, and pull the attachment away
from the nozzle.
Release the trigger safety latch and pull the
trigger to blast off the dirt.
After using the detergent attachment, rinse
it, together with the container, thoroughly
with clean water.
IMPORTANT
: Ensure you read and comply with the manufacturers instructions
regarding the use of chemical detergents.
CARE AND MAINTENANCE
WARNING: Ensure the plug is removed from the socket before carrying out any
adjustment, servicing or maintenance.
After each use
If cleaning agents have been used, thoroughly clean the detergent attachment
and bottle with clean water.
Storage
Store in an horizontal position.
If there is a danger of freezing, insert the inlet
and outlet hoses into a bucket of antifreeze
as shown in the diagram, start the machine
and allow the antifreeze to circulate. After
a short time stop the machine, and store with
the antifreeze still within the pump body.
NOTE
:
If you experience difficulty in starting the motor following a long period of storage,
it is possible that the seals within the pump have dried out and are gripping the
pistons. This problem may be alleviated by storing the machine with antifreeze
within the pump body, as described above.
If the seals are stuck however, disconnect the machine from the electrical and
water supply’s, and proceed to free them as follows:
