13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
UNDERSTANDING ADVANCED DIAGNOSTICS
When the ERROR LED warning is flashing it denotes a potential error condition.
Only use the charger after correcting the error. If the cause is not apparent,
consult a qualified person such as your Clarke dealer.
The following error warnings can occur.
1. Battery is not connected.
2. Battery voltage is too low.
3. Reverse polarity.
4. Overload.
CHARGING TIME DURATION
Different battery capacity, residual voltage and charging current will all affect
charging time.
The following table is for guidance in the case of a fully discharged battery.
• when discharging a 12V lead-acid battery to 9V, with 5A discharge
current:
• when discharging a 24V lead acid battery to 18V with 10A discharge
current.
Switch off the charger and disconnect the mains plug from the power socket.
Remove the leads from the battery and store them safely with the charger.
After the full charging cycle, use the battery to start the vehicle’s engine. If the
engine does not start (excluding a defect with the vehicle its-self), it indicates
this battery has declined any storage capacity and needs to be replaced.
B
ATTERY
S
IZE
/A
H
A
PPROXIMATE
TIME
TO
CHARGE
IN
H
OURS
(12V)
A
PPROXIMATE
TIME
TO
CHARGE
IN
H
OURS
(24V)
50
11H@30V
60
14H@30V
100
9H@14V
24H@30V
150
21H@14V
------
------
200
24H@14V
------
------
Summary of Contents for IBC7
Page 20: ......