10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CLEANING & MAINTENANCE
This pump should require no maintenance other than regular cleaning. If the
pump starts to show signs of wear or damage, contact your CLARKE dealer for
advice.
Do not use the pump if there is any damage to the mains power cable, or to
the float switch or it’s connecting cable.
Check pump installation regularly to ensure the base inlet is clear of leaves or
other debris.
Do not attempt to repair the pump yourself, as you may damage the
waterproof seal and invalidate your guarantee. Repairs must be carried out
by your CLARKE dealer, or contact the CLARKE Service Department on 020
8988 7400.
If using this pump to empty a garden pond, please note that there is a small
quantity of oil in the pump seal. If the pump or seal is damaged, possibly
caused by running the pump dry, oil may leak out, and appear as a film on
the surface of the water. The oil must be cleared to prevent any possible harm
to pond life. Disconnect the pump from the electrical supply, remove it from
the pond and clear the oil, then contact your CLARKE dealer for advice.
STORAGE
When the pump is not being used for extended periods, clean and dry it
thoroughly and store it indoors. If the pump is left in water, it must be run at
least once a week to prevent it from seizing up.
ENVIRONMENTAL RECYCLING POLICY
Through purchase of this product, the customer is taking on the
obligation to deal with the WEEE in accordance with the WEEE
regulations in relation to the treatment, recycling & recovery and
environmentally sound disposal of the WEEE.
In effect, this means that this product must not be disposed of with general
household waste. It must be disposed of according to the laws governing
Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal
facility.
WARNING: MAKE SURE THAT THE PUMP IS DISCONNECTED FROM THE
MAINS SUPPLY BEFORE CLEANING, OR PERFORMING ANY
MAINTENANCE.
Summary of Contents for HSE RANGE
Page 16: ......
