Clarke Fusion 27 01264A, Operator'S Manual, Page: 26 / 58

Page -26-
Clarke ®
Operator's Manual -Fusion 27 Battery Burnisher
HOW TO OPERATE THE MACHINE
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Pad
To install the pad on the machine, follow this procedure:
1. Position the pad centered on the pad driver.
See figure 6
2. Install and tighten the pad retainer.
How To Remove The Pad
To remove the pad on the machine, follow this procedure:
1. Loosen and remove the pad retainer.
2. Pull the pad from the pad driver. See figure 7.
Pad Pressure Operation
In order to maintain the amount of "pad pressure" being
applied to the floor, this machine comes with:
1. Pad Presssure Meter - "10 Bar" LED, (2)
Yellow, (6) Green and (2) Red. This is located
on the upper right side of the control panel.
See figure 8.
2. 90 amp circuit breaker
3.
Pad Pressure adjustment nut
The color bands on the pad pressure meter indicate
whether the pad pressure is too low (Yellow); within
recommended pad motor specifications (Green); or too
high (Red). If the machine is operating in the Red
band for more than 5 - 10 seconds, the circuit breaker
will "pop", indicating that the pressure on the floor has
exceeded the pad motor specifications. Excessive
"popping" (or blowing) of the circuit breaker will cause
the breaker to stop functioning and will need to be
replaced.
This machine operates on a "Pivot-Control" system.
This allows for the machine to "float" along the floor
consistently and continues to burnish the floor as the
pad wears. When the pad pressure meter starts to
operate in the Yellow band, it is recommended that
the pad be checked for excessive wear and possible
replacement.
If the machine operates in the (Red) band for more
than 2-3 seconds, it is recommended that you reduce
the amount of pad pressure being applied to the floor.
Refer to the "Pad Pressure Adjustment" instructions.
Figure #6
Figure 7
Figure 8
Pad Pressure
Meter
Presión de
almohadilla
Medidor
Indicateur de
Pression
du disque
EN
Retainer
Retenedor
Dispositif
de fixation
Retainer
Retenedor
Dispositif
de fixation
Yellow
Amarillo
Jaune
Green
Vert
Verde
Red
Rojo
Rouge
Factory Setting
Ajuste de fárica
Réglages d'usine
Recommended
Setting
Ajuste
recomendado
Réglages
recommandés
https://harrissupplyind.com - To Order Parts Call 608-268-8080