Clarke ECSS-1, Assembly And Instruction Manual

Page: 8 / 16

8
OPERATING
WHEN SHARPENING, ALWAYS WEAR SAFETY GOGGLES.
FITTING THE CHAIN TO THE
SHARPENER
1. Lift up the adjustment wedge
(G) and unscrew the fastening
screw (F), see Fig 8.
2. Place the chainsaw chain on
the chain holder assembly (J).
•
There is a diagram on the
chainsaw holder indicating
which way the teeth should
be facing
ADJUSTMENTS
ADJUSTING THE GRINDING ANGLE
1. Rotate the chain holder
assembly (J) to the required
angle.
•
Most chainsaw chains have a
cutting tooth angle of 15° or
30°. Check the chain
packaging for infomation.
2. Tighten the angle adjustment screw (L).
•
Do not over tighten. The chain holder assembly should be able to
move when required but it must stay in the set position when
sharpening.
•
Do not rotate the chain holder assembly (J) when the grinding disc
is moving.
•
The chain holder assembly (J) clicks into place at 15° or 30°
degrees, shown by the angle indicator (K), see Fig 9.
ADJUSTING THE MAXIMUM SHARPENING DEPTH
3. Adjust the maximum sharpening depth using the depth limiter (N).
• Start grinding with the most worn-out tooth and sharpen all other
teeth to the same depth.
Fig 8
Fig 9