Clarke Devil 370P, Operating & Maintenance Instructions

Page: 4 / 12

4
4. ALWAYS disconnect from the mains supply before moving the heater, or
performing any cleaning or maintenance tasks.
5. Inspect the mains cable regularly for signs of damage. DO NOT use if it is
damaged, and ALWAYS keep it away from the source of heat.
6. Check the heater for damage before use. DO NOT use if the heater tubes
are damaged or broken. Any damage should be properly repaired or the
part replaced. If in doubt,
DO NOT use. Consult your local Clarke dealer.
3) SERVICE & REPAIRS
1. If necessary, have your heater repaired by a qualified person using
identical replacement parts. This will ensure that the safety of the
appliance is maintained.
Additionally, please keep these instructions in a safe place for future
reference.
ELECTRICAL CONNECTIONS
DEVIL 370P & 370SP HEATER UNITS
The 370 models are provided with a 13 amp BS 1363 plug, fitted with a 13amp fuse
and MUST be connected to a standard, 230 Volt (50Hz) electrical supply, preferably
through a suitably fused isolator switch.
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead should be wired up in accordance
with the following colour code:
Green & Yellow - Earth
Blue - Neutral
Brown - Live
As the colours of the flexible cable of this appliance may not correspond with
the coloured markings identifying terminals in your plug, proceed as follows:
• Connect the GREEN & YELLOW coloured cord to the plug terminal
marked with a letter E or Earth symbol “
” or coloured GREEN or
GREEN & YELLOW.
• Connect the BROWN coloured cord to the plug terminal marked a
letter “L” or coloured RED.
• Connect the BLUE coloured cord to the plug terminal marked a
letter “N” or coloured BLACK.