6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
UNPACKING
When unpacking, check the heater for possible shipping damage. Should any
damage be apparent, please notify your Clarke dealer immediately.
Your heater is fully assembled,- only the electrical and gas supplies need
connecting. Retain any plastic cover caps (attached to the inlet connector
and hose/regulator assembly) for future storage.
PROPANE GAS SUPPLY
These heaters are designed for use with PROPANE GAS ONLY. Gas cylinders are
not supplied, but are readily available from builders merchants or gas suppliers
etc.
This range of portable, direct fired gas heaters is designed to BS 4096 for
industrial applications to give safe, efficient and reliable operation.
As with all mechanical equipment, optimum performance will only be
achieved if the correct operation and servicing procedures are followed.
GAS CONNECTION
Connect the free end of the gas hose to the gas inlet connection on the
heater and tighten to ensure there are no gas leaks. Before attaching the
regulator to the gas cylinder, ensure the mating parts are free from grease and
dirt and are undamaged.
Fit the regulator to the cylinder,
tightening the thread as tight as
possible with a propane spanner,
noting that the threads are LEFT
HANDED. To check for leaks, use
soapy water or liquid soap applied to
each of the connections. Any
bubbles formed indicate a leak.
Correct all leaks immediately.
IMPORTANT: The gas hose and
cylinder must ALWAYS be located well
behind the heater.
WARNING: PROPANE GAS CYLINDERS MUST BE USED AND STORED IN
ACCORDANCE WITH THE HIGHLY FLAMMABLE LIQUIDS AND LIQUEFIED
PETROLEUM GASES REGULATIONS 1972
’
Summary of Contents for DEVIL 1600
Page 24: ......
