21
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Undo the blade retaining nut
using the wrench and spindle key
supplied as shown.
4. Take off the nut and outer flange
and remove the old saw blade.
• Replacement blades are
available from our parts
department (part number
ZLGCTS16114).
5. Clean the blade flange faces
thoroughly before fitting the new blade.
6. Mount and fasten the new blade in reverse order.
IMPORTANT: Note the running direction. The cutting angle of the teeth must
point in the running direction, i.e. forwards (see the arrow on the blade
guard).
7. Loosen the bolt on the riving knife
clamping plate by a few turns.
8. Adjust the riving knife until there is
a 3-5 mm gap between the riving
knife and the saw blade.
9. Tighten the riving knife clamp.
10. Replace the table insert.
11. Replace the saw blade guard.
12. Check to make sure that all
components are properly
mounted and in good working
condition, before you begin working with the saw again.
WARNING: RESET THE RIVING KNIFE EACH TIME THE SAW BLADE IS
REPLACED (STEP 7 ABOVE).
