18
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6. Always push the workpiece through to the end of the riving knife using a
push stick.
7. Do not remove the offcut piece until the blade has stopped spinning.
8. Secure long workpieces against falling off at the end of the cut (e.g. with a
roller stand etc.).
CUTTING NARROW WORKPIECES
Always use a push stick when the
workpiece is smaller than 120 mm in
width.
When not in use, place the push stick
in its storage clip on the side of the
saw.
Replace a worn or damaged push
stick immediately.
BEVEL CUTS
Bevel cuts must always be made using the parallel fence.
1. Loosen the bevel lock.
2. Select the desired angle on the
scale.
3. Retighten the bevel lock to lock
the blade at the selected angle.
4. Set the parallel fence.
5. Perform the cut as you would for
a ripping cut.
