17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
GENERAL MAINTENANCE
• Keep your scroll saw clean.
• Do not allow pitch to accumulate on the saw table. Clean it with
gum and pitch remover.
POWER CABLE
CLEANING
• Never use water or chemical cleaners to clean your scroll saw. Wipe
clean with a dry cloth.
• Always store your scroll saw in a dry place. Keep all working controls
free of dust.
LUBRICATION
Lubricate the arm bearings with oil after 10 hours of use. Re-oil after every 50
hours of use or whenever there is a squeak coming from the bearings as
follows:
1. Turn saw on its side.
2. Prise off the rubber caps covering the pivot shafts.
3. Squirt a small amount of SAE 20 oil around the shaft end and bronze
bearing.
4. Let the oil soak in overnight in this condition. Next day repeat the above
procedure for the opposite side of the saw.
WARNING: TURN OFF AND UNPLUG THE SAW BEFORE CARRYING OUT ANY
MAINTENANCE WORK ON YOUR SCROLL SAW.
WARNING: IF THE POWER CABLE IS WORN, CUT, OR DAMAGED IN ANY
WAY, HAVE IT REPLACED IMMEDIATELY BY A QUALIFIED SERVICE
TECHNICIAN. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL
INJURY.
Summary of Contents for CSS16VB
Page 20: ......
