8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
INSERTING A DRILL BIT / CHISEL
The chuck clamps SDS drill bits and chisels without the need for a chuck key.
1. Pull back the collar.
2. Insert the bit.
3. Turn the bit in the chuck until it
latches.
4. Release the collar to lock in
place.
5. Check by pulling the bit to see if it
is locked in place.
IMPORTANT: Always clean the shaft
of the drill bit before inserting into the chuck.
IMPORTANT: Do not allow dust or debris to get inside the chuck as this will
cause problems in the future.
REMOVING A BIT
1. Slide the collar to the rear and pull the bit out ofthe chuck.
USING THE DRILL CHUCK ADAPTOR
When drilling with non SDS drill bits, a
13mm chuck (supplied) can be
inserted into the SDS chuck as shown.
Use the supplied chuck key to open/
close the chuck jaws.
CAUTION: WHEN REMOVING A BIT FROM THE DRILL, REMEMBER THAT IT
MAY BE EXTREMELY HOT. EITHER ALLOW IT TO COOL DOWN FIRST OR USE
INDUSTRIAL GLOVES TO REMOVE THE BIT.
