Clarke CPSB200, Operation & Maintenance Instructions Manual

Page: 7 / 20

7
ASSEMBLE THE FRAME
1.
Fig 3
Slide the axle through the axle
holes located at the bottom of the
handlebars, see Fig 3.
2. Slide a washer onto each end of
the axle.
3.
Fig 4
Place a wheel onto each end of
the axle then slide a washer onto
the axle.
4. Use the circlip provided to secure
the wheel, see Fig 4.
5. Place the cover over the wheel.
ATTACH FRONT LEG
1.
Fig 5
Roll the tank over so that handlebars
are now facing down.
2. Align the holes of the front foot with
the holes in the foot mount on the
front side of the tank, see Fig 5.
3. Insert a split pin through the holes and
bend it so the front foot cannot
slide off the foot mount.
ATTACH THE HOSE
1.
Fig 6
Slide the hose onto the outlet pipe
on the bottom of the sandblaster
as shown in Fig 6.
2. Tighten the clip shown to secure
the hose.
3. Connect the sandblasting gun to
the other end of the hose in a
similar manner.