Clarke CPSB200, Operation & Maintenance Instructions Manual

Page: 5 / 20

5
15. Always check to make sure that the trigger is not on before connecting
the sandblaster to air supply.
16. Store the sandblaster out of the reach of children and untrained persons.
Tools may be dangerous in the hands of untrained users.
17. Drain water trap periodically during use. Do not allow moisture to fill more
than 1/2 of the water trap bowl. Do not leave water standing in the water
trap when storing the sandblaster.
18. Do not allow the sandblaster to sit pressurised while unattended or not in
use
.
19. Periodically check the Valves, hoses and nozzles that carry the abrasive
medium after it leaves the pressure tank these are subjected to the
abrasive blasting action so will wear out more quickly than other
components.
20. Release the air pressure in the tank before opening. See “Releasing
Pressure from the Tank” section, Make sure the pressure gauge reads “0”
before opening the tank. Do not attempt any maintenance on the
sandblaster until the pressure gauge reads “0”, and it has been
disconnected from the air supply.
21. Maintain correct air pressure whenever working. Do not allow pressure to
exceed 125 psi. If the safety valve does not release excess air pressure, stop
all work and release pressure from the tank (see “Releasing Pressure from
the Tank” section)., investigate the cause and correct it before continuing
use
22. Always make sure there is adequate ventilation. Do not sandblast in
confined areas,
23. In the case of injury seek expert medical advice immediately.