8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
FITTING THE SANDING SHEET
With the sander disconnected from the power supply, select the sanding
sheet appropriate for the task and attach it to the base plate as follows. Either
plain sanding sheets or prepared sheets for hook and loop attachment can
be used.
PAPER SANDING SHEETS
1. Lift the retaining clips to the open
position and insert one end of the
sanding sheets under the
retaining clip.
2. Set the clip back in the retaining
position to hold the sheet and
lightly stretch it over the
baseplate, ensuring it is not folded
or wrinkled, then position it under
the other retaining clip.
3. Lock the second clip back into the retaining position.
4. Check the paper lays straight and
flat on the baseplate. If not,
release either clip and adjust the
sheet before resetting the clip.
HOOK AND LOOP SANDING SHEETS
1. Align the sanding sheet so that
the holes align with those in the
baseplate, press the sheet evenly
onto the base plate to attach it.
REPLACEMENT SHEETS
The following sanding sheets are available from your CLARKE dealer.
Grit
Size (mm)
Part No
60
93 x 287 mm
6502075
120
93 x 287 mm
6502076
240
93 x 287 mm
6502077
Summary of Contents for COS210
Page 12: ......
