9
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
OPERATION
IMPORTANT: To avoid accidental starting, ensure the drill is switched OFF
before plugging in to the mains. To do this, briefly pull the switch, and release
to ensure the trigger lock is not set in the ‘lock’ position.
INSERTING A DRILL BIT
1. Open the chuck by rotating the
chuck sleeve anticlockwise until
the jaws are open sufficiently to
take the drill bit.
2. Place the drill bit in the jaws of the
chuck as far as it will go.
3. Insert the chuck key in one of the
three holes in the chuck and
tighten in a clockwise direction.
• Make sure the head of the chuck
key is firmly located on the cog
barrel of the chuck when tightening.
REMOVE THE CHUCK KEY BEFORE OPERATING THE DRILL.
• To remove the bit, release by inserting the chuck key in one of the holes
and turning in an anticlockwise direction.
SWITCHING ON & CONTINUOUS OPERATION
1. Plug into a 13 amp socket and squeeze the trigger to start the drill.
2. During use, press the trigger lock-on button & the drill will run continuously.
Squeeze the trigger again briefly to release the trigger lock & stop the drill.
HAMMER DRILL SELECTION
Rotate the ‘Drill/Hammer Drill’ mode
selection switch so that the ‘Hammer’
symbol is aligned with the raised mark
on the drill body.
NORMAL DRILL SELECTION
Rotate the drill/hammer drill mode
selection switch so that the ‘Drill’
symbol is aligned with the raised mark
on the drill body.
NOTE: Both these operations should only be performed when the drill is at a
complete stop.
