16
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PERFORMING A SLIDING CUT
The guide rail allows cutting larger
workpieces up to 340 mm x 78 mm
using an out-down-back sliding
motion.
1. Release the slide rail lock.
2. Pull the saw head towards you (1)
and switch the saw on as
mentioned on the previous page.
3. Lower the saw blade (2) into the
workpiece and push the head
back (3) to complete the cut.
•
Do not perform sliding cuts on
workpieces smaller than 50 x 100
mm.
•
Remember to lock the saw head
in the rear position when the
sliding cuts are finished.
MITRE CROSS-CUT
1. Release the table mitre lock by
twisting the handle anticlockwise.
2. Press and hold the latch down.
3. Move the arm until the pointer
lines up with the required mitre
angle on the scale.
4. Release the latch to re-secure the
mitre lock.
•
Tighten the table mitre lock
before use.
•
Allow the blade to cut freely. Do not force the tool.
•
Proceed as for a vertical straight cross-cut.
NOTE:
When mitering the end of a piece of wood with a small off-cut,
position the wood to ensure that the off-cut is to the side of the
blade with the greater angle to the fence; i.e. left mitre, offcut to
the right - right mitre, off-cut to the left.
Summary of Contents for CMS250S
Page 28: ......
