9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Take a diagonal measurement as shown in Fig.7. When these two measures
are equal the frame is square. Adjust the frame until they are equal to
within 1".
5. Four anchors (14) are provided
to secure the structure. They
are to be attached to the bent
corner legs (11) at each corner
of the shelter.
6. Screw the anchor (#14) into the
ground on the inside of the
shelter.
7. Secure with cable (#15) and
cable clamp (#16) (as shown in
Fig.8.
STEP 6: INSTALLING THE FRONT AND BACK PANELS
The front panel has a zippered door to allow entry to the shelter. Be sure to
locate this panel at the desired end and ensure the zipper is in the closed
position while installing.
The back panel is a solid piece of fabric. Both the panels are installed in the
same fashion.
CAUTION: THE SHELTER MUST BE WELL ANCHORED. DO NOT ATTEMPT TO
INSTALL ANY OF THE FABRIC BEFORE THE FRAME IS PROPERLY
ANCHORED. IF THE GROUND IS HARD OR ROCKY, PRE-DRILL HOLES
BEFORE INSERTING THE ANCHORS.
Summary of Contents for CIS8612
Page 16: ......
