11
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
•
The battery should be fully discharged before recharging in order to
achieve its optimum performance. Constant topping up after only a small
amount of charge has been used will, in effect, reduce its capacity.
•
Ni-Cad batteries will slowly lose their power whilst in storage. Do not leave
the batteries in this state for any length of time.
OPERATION
ALWAYS BE SURE THAT THE TOOL IS SWITCHED OFF BEFORE ATTACHING
OR REMOVING A SOCKET. ALWAYS TAKE CARE TO USE THE CORRECT
SIZE SOCKET FOR BOLTS AND NUTS. AN INCORRECT SOCKET WILL CAUSE
DAMAGE TO THE BOLT OR NUT.
1. Align the chosen socket and simply push it onto the anvil. Use only ½”
square drive impact sockets supplied or as listed on page 13.
2. Squeeze the trigger to start the wrench. Release the trigger to stop.
3. To run the impact wrench in reverse, push the switch-bar through the drive
unit. The direction of rotation is shown on the end face of the switch-bar.
•
The switchbar selects the forward or reverse direction of rotation. Do not
move the switch-bar when the spindle is moving. When the switch-bar is in
the central position the trigger is locked.
4. Always check the direction of rotation before operation.
5. Turn off the wrench as soon as the impact sound is heard.
Note: As the battery becomes discharged, the power available will
drop. Operating the machine at low speed will cause a reduction
in torque.
6. When discharged, recharge the battery pack as on page 10.
LOOSENING A WHEEL NUT
1. Remove any wheel trim, before selecting the appropriate socket and
placing firmly on the square drive of the wrench.
2. With the switchbar in the REVERSE running position, and holding the
wrench firmly in BOTH HANDS, pull the trigger. The nut will be impacted
repeatedly until it is loosened.
IMPORTANT!
Release the trigger
immediately when the nut begins to loosen.
3. Jack up the vehicle according to the vehicles handbook so that the
wheel is clear of the ground, then proceed to fully undo the wheel nuts.
Summary of Contents for CIR220
Page 16: ......
