11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
STEP 5: INSTALLING THE FRONT AND BACK COVERS
The front cover has a zippered door to allow entry to the garage. Be sure to
locate this cover at the desired end and ensure the zipper is in the fully closed
position while installing.
The back cover is a solid piece of fabric. Both covers are installed in the same
fashion.
1. Thread both ends of the strap through the spindle of two ratchets to make
sure the strap will not be lost inside the cover sleeve. Raise and lower the
handle several times to wind the strap onto the spindle as shown above.
2. Begin with the front cover and first locate the webbing strap that runs
around the perimeter of the cover.
• The webbing is exposed at the apex, the shoulders and the feet of
the cover.
3. Using a rubber mallet if necessary, disconnect the apex tube (#5) from the
connector (#12) and loop the strap over the connector so it lays with the
garage. Re-fit tube (#5) to the connector as shown in Diagram J detail 2.
Summary of Contents for CIG91216
Page 16: ......
