9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
2. Heat the sleeve evenly.
DE-FREEZING WATER PIPES
Fit the reflector nozzle to the front of the hot air gun.
1. Always heat frozen areas inwards from the edge to the centre.
2. Take special care when defrosting plastic pipes.
3. Provide protection against heat damage to nearby paint and wall
coverings where necessary.
4. Be aware that copper gas pipes can be difficult to distinguish from copper
water pipes. Always check first.
5. Copper pipes are soldered together, therefore should not be heated
above 200
o
C.
MAINTENANCE
This hot air gun is maintenance free, except always ensure that the air intake
vents are kept clean. If used in a dusty environment clean the tool with low
pressure compressed air.
ENVIRONMENTAL PROTECTION
Through the purchase of this product, the customer is taking on the obligation
to deal with any waste electrical/electronic equipment in accordance with
the WEEE Regulations in relation to the treatment, recycling, recovery and
environmentally sound disposal of the WEEE.
In effect, this means that this product must not be disposed of with general
household waste. It must be disposed of according to the laws governing
Waste Electrical and Electronic Equipment (WEEE) at a rcognised disposal
facility.
