General Drilling Advice
•
After drilling material to the full depth, do not simply pull out the drill but maintain
chuck rotation to ease withdrawal.
•
Keep drill bits sharpened for optimum performance.
•
Always drill directly in line with the bit. Do not use sideways movement as this may
damage the drill or cause the bit to break.
•
Always use a cutting lubricant when drilling all metals except brass and cast iron
which should be drilled dry.
•
If the drill is not cutting the metal then sharpen the drill, ensuring the various cutting angles
are correct. Consult a suitable book of reference or a qualified technician.
If in doubt, contact your nearest Clarke dealer.
Auxiliary Handle And Depth Stop:
The depth stop is fitted with the auxiliary handle and can only be used if this handle is
installed, to install, simply locate the handle assembly over the chuck and onto the body of
the drill, insert the depth stop rod into the holder in the handle assy, rotate the handle to the
desired position and secure in position by turning the handle clockwise, DO NOT overtighten.
To set the depth stop, loosen the handle by turning anticlockwise sufficiently to be able to
slide the rod or and out to the required position, the scale markings on the rod are for
reference only.
HANDLE
HOLDER
DEPTH STOP ROD
Spare Parts
Item
Part No
Description
Qty
01
TMC82001
Chuck
1
02
TMC82002
Chuck Securing Screw
1
03
TMC82003
Chuck Key
1
04
TMC82004
Auxiliary Handle Assembly
1
05
TMC82005
Depth Gauge Rod
1
06
TMC82006
Power Cable Incl. Plug
1
6
