14
To adjust the chain tension, proceed as follows:
1
Ensure the chain brake handle is in the
disengaged
position (the chain
brake handle should be pulled back towards the handle).
2
Loosen the housing cover by slightly rotating the housing cover lock , (do
not remove). See diagram below.
3
Use the blade tensioning dial to adjust the tension of the chain.
Turn
clockwise
to decrease the chain tension and
anticlockwise
to
increase it.
4
Pull the chain gently downwards in the centre of the bar. The chain
is correctly adjusted when pulling only results in it moving 2-3 mm away
from the chain bar. See centre diagram below.
GETTING STARTED
Housing Cover Lock
Blade Tensioning Dial
19
CUTTING INSTRUCTIONS
1. FELLING A TREE
Felling is the term for cutting down a tree. Small trees with a diameter of 15-18
cm can usually be felled using a single cut. Larger trees require notch cuts, this
will determine the direction at which the tree will fall. Only attempt felling
operations that are within the capabilities of the saw.
WARNING!
A retreat path must be planned and cleared before any cutting is
started. See diagram below.
The direction of fall is controlled by the notch cut. Before any cuts are made,
consider the location of larger branches and the natural lean of the tree to
determine the position of the notch cut.
WARNING!
Do not cut down a tree during high or changing winds or if there is a
danger to property. Do not cut down a tree if there is a risk of striking
phone or power wires.
WARNING!
Make sure the danger zone is identified & access is restricted for
onlookers.
